Filter
Top Products
WFL 2060 & WFR 2460 Service Tips
WFL 2060 & WFR 2460 Service Tips
--
--
Troubleshooting (3)
Troubleshooting (3)
75
Symptom Problem Solution
Washer overheats.
Control module has
failed.
NTC failed.
Check voltage to heater. If voltage is present when heater
shouldn’t be on, replace faulty control module.
Disconnect NTC and measure resistance at terminals (~ 5.4 –
6.5 kΩ @ 20ºC (68ºF)). Replace NTC if faulty.
Door won’t lock.
Door isn’t closed
properly.
Door latch is broken.
Door lock has failed.
Close door securely. If door won’t latch, check door latch and
door hinge alignment.
Replace broken door latch.
Measure resistance of door lock mechanism (~ 500 – 1500 Ω for
WFL 2060 or 211 – 259 Ω for WFR 2460). Replace faulty door
lock mechanism.
Washer won’t spin
over 800 RPM
(WFR 2460).
Replacement control
module wasn’t
configured when
installed.
Use test T5 on test program (pp. 43, 61) to configure control
module to U.S. settings (42010011).
Washer has wrong
wash cycles and hot
water inlet doesn’t
work (WFL 2060).
Replacement control
module wasn’t
configured when
installed.
Use instructions on page 42 to set dipswitches on control
module (p.c. board) to U.S. settings.
WARNING! Unplug washer before starting any repairs.
1st Edition/Revision 5 (1/20/04)