Filter
Top Products
Installation
F232135
54
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Control Function Test
1. The machine should be cleaned after the
installation is complete. A function test should
then be executed on the unloaded machine.
2. Check the power supply for correct voltage,
phase, and cycles to be certain they are correct
for the machine.
3. Open manual shut-off valves to the machine.
4. Turn on electric power.
5. Check the door interlock before starting
operation:
a. Open the loading door.
For coin-operated machines, press the round
button on the door handle and turn the door
handle downward.
For machines intended for use in on-premises
laundries, press and hold the door-unlock
button on the left side of the control panel.
Press the round button on the door handle and
turn the door handle downward.
b. Attempt to start the machine with the door
open. The machine should not start with the
door open.
c. Close the door without locking it and attempt
to start the machine. The machine should not
start with the door unlocked.
d. Close and lock the door and start a cycle.
Attempt to open the door while the cycle is in
progress. The door should not open.
If the door lock and interlock are not functioning
properly, call a service technician.
6. Run a complete cycle, checking operation of
water inlet valves, drain, and extract functions.
7. Check that cylinder rotation is counterclockwise
in the extract step. If rotation is not
counterclockwise in the extract step, disconnect
power. For variable-speed models, have a
qualified electrician reverse any two motor leads
at the AC drive terminal block (terminals U, V,
and W). For 2 speed models, have a qualified
electrician use the wiring diagram included with
the machine to determine which input power
leads should be switched.