Filter
Top Products
76 9001900
Section 4 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electrical shock, fire, explosion, serious injury or death:
• Disconnect electrical power to the washer-extractor before servicing it.
• Close the gas shut-off valve to the washer-extractor (when applicable) before servicing it.
• Never start the washer-extractor with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer-extractor is properly grounded.
W461R1
WARNING
31. MOTOR REMOVAL AND REPLACEMENT
(100, 135 and 165-Pound Capacity Models)
Refer to Figure 16.
REMOVAL
a. Turn power off to the machine.
b. Remove the rear panel. Refer to Paragraph 24.
c. Remove the top cover. Refer to Paragraph 19.
d. Remove the drive belt. Refer to Paragraph 26.
e. Loosen the motor pulley’s setscrew and remove
the motor pulley from the motor.
f. Disconnect the motor wiring.
g. Disconnect the motor fan wiring.
h. Remove the motor fan from the motor.
i. Remove the motor from the motor plate.
j. Remove the motor from the machine.
REPLACEMENT
a. Connect the motor wiring.
b. Reinstall the motor onto the motor plate.
c. Reinstall the motor pulley to the motor and
check the pulley’s alignment.
d. Reinstall the belt.
e. Connect the motor fan wiring.
f. Reinstall the motor fan onto the motor.
g. Reinstall the motor pulley onto the motor and
check the pulley’s alignment.
h. Replace the rear panel. Refer to Paragraph 24.
i. Replace the top cover. Refer to Paragraph 19.
Figure 16
CFD2004S
Motor
Pulley
Motor Fan
Motor
Plate