Alliance Laundry Systems HX Washer User Manual


  Open as PDF
of 78
 
9001900 63
Section 3 Troubleshooting
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
17. EXCESSIVE CYCLE TIME
When experiencing excessive cycle time, there are three main causes which are as follows:
a. Fill Time:
(1) Check for excessively long fill times. Refer to the “Fill Alarm Analysis” flowchart if any are found.
(2) Check for excessively long programmed fill times.
NOTE: All pre-programmed fill times are for 5 minutes. Any fill should easily complete during this time.
b. Drain Time:
(1) Look for excessively long programmed drain times (i.e., greater than one minute).
NOTE: Any drain step should not exceed 30-40 seconds.
c. Unnecessary Programming Steps:
(1) E.g., in the first fill of a cycle, if “S02 CXX 0:00:45” “SUPPLY1” is programmed for 45 seconds and
“S03 CXX 0:00:45” “SUPPLY2” is programmed for 45 seconds, the two steps can be accomplished
together at the same time, saving 45 seconds. Refer to the “Programming Multiple Supply Steps” section
of your washer-extractor’s programming manual.
 previous next