Filter
Top Products
504524
17
Electrical Connection . . .
(Three-Wire Power Cord)
1. Remove the screw and terminal block access cover
from the rear of the dryer unit cabinet.
2. Insert ends of direct wire through power supply hole
(containing proper strain relief) in rear of dryer unit
cabinet. See following page. Connect the power
cord,or direct wiring, to the appropriate terminal
block terminals using the three wire-binding
(10-32x3/8") screws from the accessories pack in
the envelope shipped inside the dryer unit
cylinder. If the dryer unit had previously been
connected with a four-wire power cord, remove the
four-wire power cord by reversing procedures under
Four-Wire Power Cord instructions.
IMPORTANT: Use only a U.L. listed No. 10 AWG
(copper wire only) three conductor power supply cord
kit rated 240 Volts (minimum) 30 Amperes and
labeled as suitable for use in a clothes dryer unit.
3. Tighten these wire-binding screws firmly.
IMPORTANT: Failure to tighten these screws firmly
may result in wire failure at the terminal block.
4. Secure the strain relief to the power cord, or wires,
where they enter the dryer unit cabinet.
5. Check the continuity of the ground connection before
plugging the cord into an outlet. Use an acceptable
indicating device connected to the center grounding
pin of the plug and the green screw on the back of the
cabinet.
6. Reinstall access cover and screw.
The dryer unit is grounded to neutral
conductor at the terminal block. If local
codes do not permit grounding through the
neutral, proceed as shown on Four Wire
Connection instructions.
W148
To reduce the risk of electric shock,
disconnect the electrical service to the dryer
unit before proceeding.
W149
WARNING
D357IE3A
GROUNDING
PIN
INDICATING
DEVICE
(MUST SHOW
CONTINUITY)
GROUND SCREW
ON BACK
OF CABINET