Copying from the Bypass Tray
25
2
Copying from the Bypass Tray
Use the bypass tray to copy onto spe-
cial paper such as OHP transparen-
cies, thick paper, thin paper, and copy
paper that cannot be loaded in the pa-
per trays.
Preparation
When copying from the bypass
tray, select [1 Sided→
→→
→1 Sided] for
copying in [Dup./Combine/Series].
You can change the initial settings.
See p.143 “Duplex Mode Priority”.
Important
❒ Paper larger than 458 mm, 18.1" in
length is likely to jam, crease, or
not feed in properly.
❒ When copying onto special paper
such as adhesive labels, always se-
lect “Face up”. If you select “Face
Down”, a paper misfeed may oc-
cur. See p.156 “Eject Copy Face Up
/ Down in Bypass Mode”.
❒
Do not use colour OHP transparen-
cies that have easily melted coatings.
Note
❒ The sizes that you can use in the
bypass tray are as follows:
❒ For paper sizes you can select in
bypass copy, see p.161 “Bypass
Tray Copy”.
❒ The machine can automatically de-
tect the following sizes as standard
size copy paper:
❒ When copying on sizes other than
those specified above, you need to
specify the paper size. See p.26
“When copying onto standard size
paper” and p.26 “When copying
onto custom size paper”.
❒ To copy onto OHP transparencies,
paper thinner than 72 g/m
2
(about
16 lb.), or paper of 127 g/m
2
(about
34 lb.) or above, you need to speci-
fy the paper type. See p.27 “When
copying onto special paper”.
❒ When printing on OHP transpar-
encies, make sure you adjust the
guides in the tray to “A4K” or
“8
1
/
2
” × 11”K” and specify [Paper
Size] in User Tools.
❒ If you place originals on the expo-
sure glass and want the copies to
be delivered face down, select
“Face down” for both ”Eject Copy
Face Up/Down in Glass Mode”
and “Eject Copy Face Up/Down in
Bypass Mode” of User Tools. For
details, see General Settings Guide.
❒ If you select OHP transparencies
or thick paper 2 in “Special paper”,
you cannot have copies delivered
face down.
❒ If you select Tab Stock, you cannot
have copies delivered face up.
❒ If you use paper larger than 458
mm, 18.1" in size, you cannot have
copies delivered face down.
❒ The maximum number of sheets
that you can load onto the bypass
tray depends on paper type. The
number should not exceed the up-
per limit.
❒ We recommend that you use a
4000ANSI lumen or brighter over-
head projector to project OHP
transparencies.
Metric
version
• Vertical: 100 – 305 mm
• Horizontal: 148 – 437.2 mm
Inch
version
• Vertical: 4.0" – 12.0"
• Horizontal: 5.9" – 17.3"
Metric
version
A3
L
, A4
L
, A5
L
, B4 JIS
L
,
B5 JIS
L
, B6 JIS
L
Inch
version
11"
×
17"
L
, 8
1
/
2
"
×
11"
L
,
5
1
/
2
"
×
8
1
/
2
"
L
VenusC1_GB_Copy_F1_FM.book Page 25 Tuesday, January 17, 2006 3:43 PM
