Network Out-of-Band Management (OOBM) for the 6600 Switch
Tasks
Ping: ping [...] [source < ip-address | vlan-id | oobm>]
Management and Configuration Guide, page C-65
Traceroute:
traceroute [...] [source <ip-address | vlan-id | oobm>]
Management and Configuration Guide, page C-67
Example
This example shows setup and use of network OOBM using the commands
described above.
Assume that the figure below describes how you want to set up your data
center.
Figure J-3. Example data center
Assume that you are configuring the switch in the left-hand rack to commu-
nicate on both the data and management networks. You might do the
following:
■ Configure an IP address on the data network.
■ Verify that out-of-band management is enabled. (It is enabled by default.)
■ Configure an IP address on the management network.
■ Verify that the switch can communicate on both networks.
J-15
