Network Out-of-Band Management (OOBM) for the 6600 Switch
Tasks
OOBM Enable/disable
To enable or disable network OOBM, use the enable or disable command.
Network OOBM is enabled by default.
Syntax:
From the OOBM context:
enable
disable
From the general configuration context:
oobm enable
oobm disable
Enables or disables networked out-of-band-management on
the switch.
OOBM is not compatible with either a management VLAN or
stacking. If you attempt to enable OOBM when a management
VLAN is enabled or when stacking is enabled, the command
will be rejected and you will receive an error message.
If an OOBM IP address exists and you disable OOBM, the
OOBM IP address configuration is maintained. If you enable
OOBM and there is a pre-existing OOBM IP address, it will
be reinstated.
Examples:
ProCurve (oobm)# enable
ProCurve (oobm)# disable
ProCurve (config)# oobm enable
ProCurve (config)# oobm disable
J-7
