Power Over Ethernet (PoE/PoE+) Operation
Displaying the Switch’s Global PoE Power Status
For example, show power-over-ethernet brief displays this output:
ProCurve(config)# show power-over-ethernet brief
Status and Counters - Port Power Status
System Power Status : No redundancy
PoE Power Status : No redundancy
Available: 600 W Used: 9 W Remaining: 591 W
Module A Power
Available: 408 W Used: 9 W Remaining: 399 W
PoE | Power Power Alloc Alloc Actual Configured Detection Power
Port | Enable Priority By Power Power Type Status Class
------ + ------- --------- ----- ------ ------ ----------- ----------- ------
A1 | Yes low usage 17 W 0.0 W Searching 0
A2 | Yes low usage 17 W 0.0 W Searching 0
A3 | Yes low usage 17 W 0.0 W Searching 0
A4 | Yes low usage 17 W 0.0 W Searching 0
A5 | Yes low usage 17 W 0.0 W Searching 0
A6 | Yes low usage 17 W 8.4 W Delivering 2
A7 | Yes low usage 17 W 0.0 W Searching 0
A8 | Yes low usage 17 W 0.0 W Searching 0
A9 | Yes low usage 17 W 0.0 W Searching 0
Figure 11-4. Example of show power-over-ethernet brief Command Output
You can also show the PoE information by slot:
ProCurve(config)# show power-over-ethernet slot A
Status and Counters - System Power Status for slot A
Maximum Power : 408 W Operational Status : On
Power In Use : 9 W +/- 6 W Usage Threshold (%) : 80
Figure 11-5. Showing the PoE Information by Slot
11-22
