Interface Access and System Information
Interface Access: Console/Serial Link, Web, and Inbound Telnet
Syntax: [no] telnet-server [listen <oobm | data | both>]
Enables or disables inbound Telnet access on a switch.
Use the
no version of the command to disable inbound Telnet
access.
The
listen parameter is available only on switches that have a
separate out-of-band management port. Values for this
parameter are:
•
oobm — inbound Telnet access is enabled only on
the out-of-band management port.
•
data — inbound Telnet access is enabled only on
the data ports.
•
both — inbound Telnet access is enabled on both
the out-of-band management port and on the data
ports. This is the default value.
Refer to Appendix I, “Network Out-of-Band Management” in
this guide for more information on out-of-band management.
The
listen parameter is not available on switches that do not
have a separate out-of-band management port.
To disable inbound Telnet access:
ProCurve(config)# no telnet-server
To re-enable inbound Telnet access:
ProCurve(config)# telnet-server
Outbound Telnet to Another Device. This feature operates indepen-
dently of the telnet-server status and enables you to Telnet to another device
that has an IP address.
7-6
