Filter
Top Products
What if … Possible fault Fix
the wash cycle finishes
too early, the "Fill/Drain"
indicator flashes and
the fault code "F A"
appears in the display?
–
The drain hose is
kinked.
–
The drain pump is
blocked.
–
Turn the program selector to
"Stop" f (the fault code
goes out).
–
Press the "On/Off" button to
turn the machine off.
–
Remove any kinks in the
hose. Clean the drain pump
(see "Machine care").
–
Turn the machine on, run the
drain program then restart
the original program (see
Operation").
water in the wash
cabinet is not heated,
the program sequence
lasts too long and the
following fault code
appears in the display:
"F01 - F03, F18, F19"?
This machine has a
resettable heater
limiter, which will
switch off the heater
in case of
over-heating. This
could be caused if
large articles cover
the heating elements,
or if the filters in the
wash cabinet are
blocked.
–
Remove the cause of the
fault.
– Remove the service panel
(see "Electrical connection").
– Press the reset button on the
temperature sensor on the
right side.
If this switch trips repeatedly,
contact the Miele Technical
Service Department before
further use. See back cover
for phone numbers.
Trouble shooting
47