Filter
Top Products
1. Setting the dosage
concentration and priming the
dosage system
Before performing any of the
following special functions, the
programming mode of the controller
needs to be accessed. See
"Accessing the programming level".
1.1 DOS 1 (Liquid detergent)
by DOS unit G 60 or C 60 (Optional
accessory)
1.1.1 Setting the dosage
concentration
^ Access the programming level E02 of
the controller (see "Accessing the
programming level").
Set the dosage concentration
according to the detergent
manufacturer’s recommendations.
Example:
The manufacturer recommends a
detergent concentration of 0.5%.
The value to be set is 0.50.
^
Turn the program selector to
"Inorganica". The display shows
either the dosage time in seconds
(for powdered detergent) or the set
dosage concentration in % (for liquid
detergent).
"10" = Dosage time of 10 seconds for
powdered detergent, or
"0.10" - "0.80" = 0.1 % - 0.8 %
concentration for liquid detergent
dosage.
^
Press and hold "Display" ß until the
desired value appears.
^ Please note the dosage setting here:
^ Press the "Display" ß button.
The dosage system will be primed
automatically. The priming is done if
the display shows "0".
Programming special functions
35