Filter
Top Products
Installation and connection
87
Connection to the drainage
syst
em
The machine drains via a drain pump
with a deliver
y head of 1 metre*. The
drain hose must not be kinked as this
restricts drainage. The swivel elbow at
the end of the hose can be turned in ei‐
ther direction, or can be detached if re‐
quired, with a sharp twist and pull.
If required, the drain hose can be exten‐
ded to a length of 5 m. The necessary
parts can be purchased from your Miele
Dealer or Miele.
* For a delivery head of more than 1 m
(up t
o a max. of 1.8 m) a replacement
drain pump will need to be fitted.
Please contact Miele or your Miele
Dealer for advice. If necessary, the
drain hose can be extended to a length
of 2.5 m. The necessary parts can be
purchased from your Miele Dealer or
Miele.
Drain hose connection:
1. Direct into a sink or basin.
Please note the following:
– Hook the hose over the edge and
secur
e.
– Make sure that the water can drain
away f
reely without hindrance.
Otherwise there is a risk of water
overflowing or of some of the
drained water being sucked back
into the machine.
2. Connected securely to a plastic drain
pipe w
ith a rubber nipple. There is no
need to use a non-return valve.
3. Connected securely to a floor gully.
4. Connected securely to a standpipe.
Please note:
Ad
apter
Nut
Hose clip
End of the hose
Fi
t adapter to the sink drain outlet
using nut .
A
ttach the end of the hose to
adapter .
Use a scr
ewdriver to tighten hose clip
up close to the nut.