Miele 06 533 690 Washer/Dryer User Manual


 
Building under a continous worktop /
in a kitchen run
,
A building-under kit (available
to order) with a cover plate to
replace the machine lid is required.
It must be fitted by suitably qualified
person to ensure electrical safety.
N.B. If you wish to push your machine
under a worktop and there is space to
do this without removing the lid the
building under kit is not necessary.
Otherwise the building under kit is
essential.
The building-under kit is supplied with
its own installation instructions.
Slides are also available to order for
fitting underneath the machine feet to
protect the floor from damage when
the machine is pushed into position
or taken out for servicing.
Connections for electricity, water and
drainage should be installed in such
a way that they remain accessible
when the machine is in place.
N = Niche height (820-930 mm)
(illustration shows machine with lid removed)
Niche height Action
820 mm None required
from 830 -
840 mm
Fit longer screw feet*
(Set to approx.
40 mm)
from 870 -
885 mm
Use one raising kit*
from 915 -
930 mm
Use two raising kits*
* accessory available to order
If the kitchen run has a continuous
furniture plinth in place, a gap must
be made for the washing machine.
Replacing the lid
If the lid has been removed in order to
fit a coverplate, ensure that, if the lid is
ever replaced, it fits securely into the
rear holders. Otherwise, it is not
properly secure for transport.
Installation and connection
67