Filter
Top Products
DLoad the drum
^
Open the drum door.
^
Load the laundry loosely into the drum.
Do not overload the drum. See the
"Programme chart" in the "Drying"
section for recommended loads for each
programme. Overloading can cause
unnecessary wear and tear to the
laundry and give a disappointing drying
result.
EClose the drum door
Make sure you have removed any
detergent dispensing aids, e.g. plastic
dispenser balls, before drying. These
dispensers can melt during the drying
programme and cause damage to the
machine and the laundry.
Make sure that no garments are caught
between the drum door and seal.
The stopcock must be open even if you
are only using the machine for drying.
FStart the programme
^
Press the flashing Start/Stop button.
The estimated programme duration will
appear in the display. The electronics
continually assess the residual moisture
content of the laundry and adjust the
estimated time remaining for a more
accurate reading. Because of this the
time displayed can alter during the
course of a programme. The time
remaining will count down in one minute
steps. The programme sequence and
the drying level reached will also be
shown in the display.
The drum lighting switches off once the
programme has started.
GRemove the laundry when the
programme has finished
In the anti-crease phase after the
programme has finished, the following
will appear alternately in the display:
Anti-crease
and
i
Programme finished.
Remove laundry, then
switch the machine off.
^ Turn the programme selector to the
Stop position.
^ Open the drum door.
^ Remove the laundry.
Check that all items have been removed
from the drum. If items are left in the
dryer, they could be damaged by
overdrying when the dryer is next used.
Important: Always remove the laundry
before switching the machine off. This is
important to ensure that the load size
indicator works correctly the next time the
machine is used.
^
Switch the machine off.
See "After each washing or drying
programme" for further information.
DRYING
35