Filter
Top Products
An unsatisfactory drying result
Problem Possible cause Remedy
The laundry is still
damp after a drying
cycle.
The load was too small
for the electronics to
assess the residual
moisture correctly.
In future dry small loads in a
timed drying programme.
The laundry has formed
a ring in the drum during
the spin because it was
distributed unevenly.
–
Turn the programme selector
to Stop.
–
Open the door and loosen
the laundry.
–
Start the drying programme
again using a lower spin
speed.
The laundry has formed
a ring in the drum during
the thermospin because
it was too damp or the
spin speed was set too
high.
Warm laundry feels
damp.
Extend the cool down time, as
described in "Settings menu J",
"Set extended cool-down".
The laundry is too
damp or too dry
after a drying cycle.
The required residual
moisture level is between
two drying levels.
Either extend or shorten the
drying times, as described in
"Settings menu J", "Alter time".
There is still water
in the drum after
drying.
There is a blockage in
the water outlet.
Clean the drain filter and the
drain pump as described in
"Problem solving guide –
Opening the drum door in the
event of a blocked drain outlet
and/or power failure".
Problem solving guide
55