Filter
Top Products
5-4
Part Name
Descriptive Picture
How To Do
Drum Re-
moval
Rear Roller
Removal
Motor/Blow-
er
Assembly
Removal
(1)
####
1.Disconnect power supply to unit.
2.Remove Top Cover.
3.Remove Console.
4.Remove Front Panel.
5.Remove Console Back Cover.
6.Remove Front Bulkhead.
7.Remove belt from Idler Pulley.
8.Grasp the Drum with one hand
and the belt with the other. Lift
the Drum and slide out the front.
Carefully spread the cabinet as
needed to gain additional
clearance.
1.Disconnect power supply to unit.
2.Remove Rear Bulkhead.
3.Remove Roller Keeper and nut.
1.Disconnect power supply to unit.
2.Remove Top Cover.
3.Remove Console.
4.Remove Front Panel.
5.Remove Console Back Cover.
6.Remove Belt from Idler Pulley.
7.Remove Drum.
8.Remove the two screws securing
the Blower Intake Panel to the
Blower Housing. Remove Blower
Intake panel.
9.Removed the screw at the
bottom of the blower housing.
10.Remove the blower attachment
screw under the Thermistor.
11.Remove two screws attaching
the motor bracket to the base.
12.Disconnect the Motor wire
harness and the two wires to the
belt switch.