Filter
Top Products
139
Troubleshooting
Error code 80, INCORRECT PROGRAMMING
Programming error/incorrect or missing parameter.
(E 10 in the Service Manual for Selecta II).
Error code 81, DRYING ERROR RMC PROGRAM
Maximum allowable RMC time exceeded (non-coin operated models only).
(E 11 in the Service Manual for Selecta II).
Error code 82, DRYING ERROR AUTOSTOP PR.
Maximum allowable Autostop time exceeded (non-coin operated models only).
(E 12 in the Service Manual for Selecta II).
Error code 83, DRYING ERROR TIME PROGRAM
Requested drying time is longer than maximum allowed (machine connected
to a payment system). (E 13 in the Service Manual for Selecta II).
Error code 84, NO GAS FLAME DETEC.
A flame was not detected on gas heated machines.
(E 14 in the Service Manual for Selecta II).
Error code 85, NO VACUUM DETECTED
The vacuum switch/pressure switch does not shut within 12 seconds after
the machine is started. (E 15 in the Service Manual for Selecta II).
Error code 86, SHORT IN VACUUM SENS.
The vacuum switch/pressure switch was already closed when an attempt
to start the machine was made. (E 16 in the Service Manual for Selecta II).
Error code 87, OPEN CIRCUIT INPUT SENSOR
The inlet thermistor or wiring to the thermistor is open.
(E 17 in the Service Manual for Selecta II).
Error code 88, OPEN CIRCUIT OUTPUT SENS.
The outlet thermistor or wiring to the thermistor is open.
(E 18 in the Service Manual for Selecta II).