Filter
Top Products
138
Troubleshooting
Error codes from DRYER PROGRAM UNIT
For more information see Service Manual for Selecta II
Error code 73, SHORT TEMP INPUT SENSOR
The thermistor element measuring the air inlet temperature to the drum,
or the wiring to the sensor has shorted.
(E 03 in the Service Manual for Selecta II).
Error code 74, SHORT TEMP OUTP. SENSOR
The thermistor element measuring the air outlet temperature from the
drum, or the wiring to the sensor has shorted.
(E 04 in the Service Manual for Selecta II).
Error code 75, FAN MOTOR TOO HOT
The thermal protection switch in the motor, or its harness, is open.
(E 05 in the Service Manual for Selecta II).
Error code 76, DRUM MOTOR TOO HOT
The thermal protection switch in the motor, or its harness, is open.
(E 06 in the Service Manual for Selecta II).
Error code 77, EXTERNAL ERROR
External equipment connected to the machine has caused error on port
P13.
(Not relevant for this machine).
Error code 78, MACHINE OVERHEATED
One of the proctection thermostats has opened due to overheating.
(E 08 in the Service Manual for Selecta II).
Error code 79, FILTER LID OPEN
The machine is started with the lint drawer open or the machine has been
operating for more than 40 hours without the lint drawer being emptied.
Close the lint drawer if it is open.
Clean the filter. (Not relevant for this machine).
Only for WD4130, WD4240