Filter
Top Products
GT-541
iii
CAUTION
Installation
Setting up and moving of the printer should only be
carried out by a qualified technician.
The printer machine weighs approximately 100 kg.
Transporting and setting up of the printer should be
carried out by four or more people.
The machine must be transported using the correct
handling points only. Do not use the cartridge
housings to move the machine. The machine may
fall down and cause injury.
The printer must be used on a suitable stable
surface, otherwise it may tip over or fall down and
cause injury.
Furthermore, the table that supports the printer
should be at least 100 cm in width and 80 cm in
depth, and should be able to bear a weight of 150
kg or more.
Do not set up the printer in a place where it will be
affected by vibration. It may become unbalanced
and fall down, which cause injury or damage to the
printer.
Do not connect the power cord until setup is
complete, otherwise the printer may operate if the
power switch is turned on by mistake, which could
result in injury.
Do not climb onto the printer or place heavy objects
on top of it, otherwise it may become unbalanced
and tip over or fall down and cause injury.
Printing
This printer should only be used by operators who
are appropriately trained in its operation.
Ensure there is adequate space left for safe
working. The Platen moves forward while operating
and it may be injured.
Do not handle the platen while printing. If your hand
gets caught between the platen or the T-shirt tray
and the covers, it may be injured.
Do not move the Platen by hand.
The Printer may be mechanically and electrically
damaged.
Do not put your hands inside the covers while the
printer’s power is turned on, otherwise your hands
may touch against moving parts and this may result
in injury.
When a problem occurs with the operation of the
printer, contact the place of purchase or a qualified
technician.
Maintenance
Wait at least 1 minute after turning off the power
switch before opening the front cover.
Do not touch the head heat sink as it may be HOT
and may cause a burn.
Be careful not to get your fingers caught when
closing the front cover, otherwise it may result in
injury to your fingers.
Do not move the Platen by hand.
The Printer may be mechanically and electrically
damaged.
Do not disassemble the ink cartridge or the waste
ink cartridge.
Take care not to let the ink, waste liquid or wash
liquid come into contact with your eyes or onto your
skin, otherwise inflammation can result. In case of
contact with eyes, do not rub but immediately rinse
the eyes with water.
Furthermore, do not drink the ink, waste liquid or
wash liquid under any circumstances, as they can
cause vomiting and diarrhea.
Keep the ink, waste liquid and wash liquid out of the
reach of children.
Use only the proper replacement parts as specified
by Brother.