Filter
Top Products
3. Getting Started
GT-541
16
3-2. Turning On/Off Your Printer
<Note>
Before you connect the power cord, make sure:
The Ink Cartridges, Waste Cartridge Tray, and Wiper Cleaner Cassette are installed.
The Rear Cover is mounted.
Keep the front space as the Platen slides out approximately 30 cm (12 inches) when operating.
3-2-1. Turning On Your Printer
(1) Connect the power cord (included) to the power cord socket of your printer.
(2) Connect the power plug to the power outlet.
Ensue the printer is connected to a suitable earth point
(3) Press the Power Switch to turn on your printer.
Your printer turns on, displays "Welcome to GT-541", and lights up the Error Lamp and the Print
Button while initializing.
The initialization requires approx. 40 seconds and will indicate when it is completed.
When the installation finishes, the machine enters standby mode.
3-2-2. Turning Off Your Printer
When you have finished using your printer, follow the instructions below to turn it off.
(1) Make sure that your printer is "standby" or "ready" mode.
(2) Select "Platen Reset" in Menu or press Platen Button to store the Platen.
(3) Press Power Switch to turn off your printer.
(4) If you are planning not to use your printer for over-two-week periods of time, disconnect the power
plug from the power outlet.
<Note>
Do not turn off your printer when it is operating. It may cause serious damage to your printer. If
you turn off your printer accidentally during the operation, immediately restart it, and then turn it off
correctly following the steps described in this section.
If the printer is unused for a long time we recommend turning on your printer once a week and
press the Head Cleaning Button to clean the Print Head. This ensures the ink is kept free flowing.
If you are planning not to use your printer for more than two weeks, follow “6-1-5. Required
Maintenance for the Long Storage" to prevent ink clogging.