Filter
Top Products
32 American Dryer Corp. 113068-7
5. GAS MODELS – Be sure that ALL gas shutoff valves are in the open position.
6. Be sure
ALL side and base panels are on the dryer.
7. Check
ALL service doors to assure that they are closed and secure.
8. Be sure lint drawer is securely in place.
NOTE: LINT DRAWER MUST BE ALL THE WAY IN PLACE TO ACTIVATE SAFETY
SWITCH OTHERWISE THE DRYER
WILL NOT START.
9. Rotate the basket (tumbler/drum) by hand to be sure it moves freely.
10. Check bolts, nuts, screws, terminals, and fittings for security.
11. Check to ensure air supply (80 psi [5.51 bar]) is connected to the dryer.
12. STEAM MODELS – Check to ensure ALL steam shutoff valves are open.
L. ELECTRICAL REQUIREMENTS
1. Electrical Requirements
It is your responsibility to have ALL electrical connections made by a properly licensed and competent
electrician to assure that the electrical installation is adequate and conforms to local and state regulations or
codes. In the absence of such codes, ALL electrical connections, materials, and workmanship must
conform to the applicable requirements of the National Electrical Code ANSI/NFPA NO. 70-LATEST
EDITION or in Canada, the Canadian Electrical Codes Parts 1 & 2 CSA C22.1-1990 or LATEST EDITION.
IMPORTANT: Failure to comply with these codes or ordinances and/or requirements stipulated in this
manual can result in personal injury or component failure.
NOTE: Component failure due to improper installation will VOID THE WARRANTY.
Each dryer should be connected to an independently protected branch circuit. The dryer must be connected
with copper wire ONLY. DO NOT use aluminum wire, which could cause a fire hazard. The copper
conductor wire or cable must be of proper ampacity and insulation in accordance with electric codes for
making ALL service connects.
NOTE: The use of aluminum wire will VOID THE WARRANTY.