Filter
Top Products
113068-7 www.amdry.com 17
e. Basket (Tumbler) Junction Box Disconnect
Remove the four (4) bolts that hold on the lower left side panel, then remove the panel. The safety
panel is next to be removed. This is done by removing the six (6) bolts on the bottom of the safety panel
where the basket (tumbler) section and the base meet. Reach into the feed through hole in the base of
the basket (tumbler) section, there will be two (2) cables there. Pull both cables through the hole into
the basket (tumbler) section. The cable with the connector on the end is for the basket (tumbler)
junction box, the other cable is for the left drum motor. Leave that cable in the basket (tumbler) section
(it
will be covered in Section F [Left Drum Motor] below). Check keying between the plug and basket
(tumbler) junction box. Insert plug into connector on the junction box and engage locking clasps. Leave
the lower left side panel and the safety panel off the dryer until left drum motor is reconnected (refer to
Section F [Left Drum Motor] below).
f. Left Drum Motor
There are two (2) different ways that the left drum motor is connected with or without the motor
disconnect junction box. The junction box is used when the connections to the left motor are made on
the back side of the motor, nearest to the basket (tumbler). When connecting the motor, bring the left
drum motor cable (refer to Section E Basket [tumbler] Junction Box Disconnect] above) and
mechanically connect it to the junction box on the motor or the external junction box with the lock nut.
There will be four (4) wires in the cable, match them with the PVC electrical tape. There should be
one (1) green wire remaining, which is used for the ground connection. Replace the screws that go on
the cover of the junction box. Bolt the safety panel back in place using the six (6) bolts removed in
Section E (Basket [tumbler] Junction Box Disconnect above), then bolt the lower left side panel back
in to place using the four (4) bolts also removed in Section E (Basket [tumbler] Junction Box Disconnect
above).