Filter
Top Products
10 American Dryer Corp. 113068-7
c. Reassemble The Basket (Tumbler) Section To The Basket (Tumbler) Base
Lift the basket (tumbler) section with a cable through the eyebolts on top of the section. Slowly lower
the basket (tumbler) section over the basket (tumbler) base. The four (4) large slots located on the
bottom of the basket (tumbler) section (one [1] slot at each corner of the basket [tumbler] section)
must be aligned with the tapped holes in the cylinder cleaves located at the top of the basket (tumbler)
section. Use the four (4) 1-1/4-12 x 3-1/2” long bolts supplied with the unit to secure the basket
(tumbler) section to the basket (tumbler) base section.
d. Reattach The Control Pendant Arm
Position the control pendant arm on the top front of the heat console section by aligning the clearance
holes in the arm over the 1/4-20 taped holes in the top of the heat console section. Use the 1/4-20 x 3”
long bolts supplied with the unit to attach the arm to the console.
e. Reconnect the internal air, electric, and water connections (refer to page 12 through page 17).