Filter
Top Products
12 American Dryer Corp. 113068-7
C. INTERNAL AIR, ELECTRIC, AND WATER CONNECTIONS
1. Air
a. Front Tilt Piston
This connection is made at the front of the dryer in the area between the lower heat console section and
the basket (tumbler) base section. To connect the 3/8” poly-flo tubing to the corresponding brass
fittings, match the marked number on the tube with the number on the brass fitting. After inserting the
corresponding tubes into the brass fittings, tighten the brass fitting nuts.
b. Rear Tilt Piston Lines
This connection is made at the rear of the dryer in the space between the lower heat console section
and the basket (tumbler) base section. Insert the 3/8” poly-flo tube coming from the basket (tumbler)
base section to the 3/8” brass fitting marked with the corresponding number. Do the same to the
second tube and brass fitting. Tighten the brass fitting nuts.