Filter
Top Products
54
J. PREPARATION FOR OPERATION/START-UP
The following items should be checked before attempting to operate the dryer:
1. Read ALL “CAUTION,” “WARNING,” and “DIRECTION” labels attached to the dryer.
2. Check incoming supply voltage to be sure that it is the same as indicated on the dryer data label affixed
behind the right control box door. In the case of 208 VAC or 230 VAC for dryers with sprinkler option,
verify single-phase (1ø) voltage is correct. THE SUPPLY VOLTAGE MUST MATCH THE ELECTRICAL
SERVICE EXACTLY.
3. GAS MODELS - Check to assure that the dryer is connected to the type of heat/gas indicated on the dryer
data label.
4. GAS MODELS - the sail switch damper assembly was installed and adjusted at the factory prior to shipping.
However, each sail switch adjustment must be checked to assure that this important
safety control is functioning.
5. GAS MODELS - be sure that ALL gas shut-off valves are in the open position.
6. Be sure ALL side and base panels are on the dryer.
7. Check ALL service doors to assure that they are closed and secure.
8. Be sure the lint drawer is securely in place.
NOTE: Lint drawer must be ALL the way in place to activate the safety switch otherwise the
dryer will not start.
9. Rotate the tumbler (basket/drum) by hand to be sure it moves freely.
10. Check bolts, nuts, screws, terminals, and fittings for security.
11. Check to insure air supply (80 PSI [5.51 bars]) is connected to the dryer.
12. STEAM MODELS - check to insure ALL steam shut-off valves are open.