Filter
Top Products
© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
Programming
F232179
18
NOTE: If the wash load becomes out of balance,
the machine will attempt to balance the load. After
three failed attempts the display will light the
leftmost digit and a lower spin will be used to
complete the cycle. Refer to Figure 2.
Figure 2
NOTE: External chemical supply signals and any
related flush valves will activate approximately 15
seconds after machine begins to fill with water. If
programmed water level is reached prior to 15
seconds, no chemical supply signal will be
activated.
*NOTE: Only supply 2 (SUP2) and supply 3
(SUP3) have independent water valves to flush
their respective compartment. Compartment 1 will
flush whenever machine is filling with water.
**NOTE: ADD BLEACH LED lights if Supply 2 is
the only supply programmed. If set up for
"bEEP"(refer to SETUP Mode section), buzzer will
sound on and off for the first eight seconds. The
Supply 2 and ADD BLEACH LED remain on for
45 seconds or until the fill is complete, whichever
comes first.
***NOTE: Selecting "EFIL" (Extra fill) in SETUP
Mode will remove supply 5 and supply 6 as optional
supply signals.
CHM522R
1 Out-of-Balance LED
WASH
ADD
BLEACH
RINSE
SPIN
DOOR
CLEAN
FILTER
NORMAL
LIGHT SOIL
UNIFORMS
HEAVY SOIL
STAINED
DELICATE
HOT
HOT
HOT HOT
HOT
HOT
WARM
COLD
START
PERM PRESS
VISA
TM
1
Supply Programmed External Chemical Supply Signal Compartment Flushed
SUP0 None None
SUP1 Supply 1 Compartment 1*
SUP2 Supply 2** Compartment 2
SUP3 Supply 3 Compartment 3
SUP4 Supply 4 No compartment Flush*
SUP5 Supply 5*** No compartment Flush*
SUP6 Supply 6*** No compartment Flush*
SUP7 Supply 7 Compartment 3
Table 2