Filter
Top Products
© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
Programming
F232179
8
Cycle and Error Count
1. To read, enter PROGRAM Mode. Refer to
Entering Program Mode.
2. Press START (Enter) keypad. Display shows
“Erdn” (indicates Drain Error count).
3. Press START (Enter) keypad. Display shows a
number (2 or 3 digits) showing how many drain
errors have occurred. This number can range
from ‘00’ to ‘255’, and cannot be set to zero.
4. Press START (Enter) keypad. Display shows
“ErFL” (indicates Fill Error count).
5. Press START (Enter) keypad. Display shows a
number (2 or 3 digits showing how many fill
errors have occurred. This number can range
from ‘00’ to 255’, and cannot be set to zero.
6. Press START (Enter) keypad. Display shows
“CYC “ (indicates Cycle count).
7. Press START (Enter) keypad. Displays show a
number (up to 4 digits) showing how many
complete cycles have been operated. This
excludes cycles stopped because of an error.
8. Press START (Enter) keypad.
9. If display does not show “E Pr”, control will
revert to normal PROGRAM mode.
10. If display shows “E Pr”, this is for factory
reference regarding power interruption. Press
START (Enter) keypad. A number will display.
Press START (Enter) keypad. After a brief pause,
the control will display normal PROGRAM
mode.
Setup Mode (For Earlier Models)
NOTE: In SETUP Mode, certain machine
functions can be configured. The settings in this
mode are related to how the machine is equipped
from the factory. Usually, these would not be
changed in this field.
NOTE: Enter SETUP Mode through the
PROGRAM Mode.
1. Press (*) keypad. Display will show “FAr” or
“CEL”.
NOTE: This selects whether temperatures display
in degrees Fahrenheit (F) or Celsius (C), if control
is equipped with a temperature sensor. Change
selection by pressing (∧) or (∨) keypad.
NOTE: Changing degrees “FAr” or “CEL” only
has an effect if the control has a temperature probe
connected and/or heat capability.
2. Press START (Enter) keypad.
3. Model will display “HEAt” or “noHt”. Change
the selection by pressing the (∧) or (∨) keypad.
4. Press START (Enter) keypad to continue to the
next step.
NOTE: If set for “HEAt”, the control has heat
capability enabled. The washer-extractor MUST
have electric or steam heat and a temperature
probe. If display shows “noHt” or if the message
“HEAt” or “noHt” does NOT display, the control
does NOT have heat capability.
5. Certain models will display “EFIL” or “ESUP”.
For these models, the control provides a spare
output (for certain models). The spare output can
be set up to control an extra fill valve (“EFIL”),
with the ability to fill to a programmable water
level (just as for regular fills), OR the spare
output can be set up to control an extra chemical
supply signal (“ESUP”).
6. Press START (Enter) keypad.
7. Certain models display “bEEP” (control sounds
beeper during Add Bleach [Supply 2]) or “nobP”
(control does NOT sound beeper during Add
Bleach [Supply 2]). Change selection by pressing
(∧) or (∨) keypad.
8. Press START (Enter) keypad.
NOTE: If “EFIL” or “ESUP” does NOT display,
the extra fill capability is NOT present. If either
message does display, change the selection by
pressing the (∧) or (∨) keypad. Press START
(Enter) keypad to return to PROGRAM Mode.
Refer to “Programming Cycle Segments” section
for additional information.