A SERVICE OF

logo

4. PARAMETERS
4.3 Parameter Settings
4.3.1 Checking the parameter settings
Checking the setup data
Step 1 Turn the main power switch (rear panel) on while pressing the Load key, and
active the parameter setting mode.
If the parameter setting mode is already activated, this step can be omitted.
Step 2 Press the Coordinate switch key, enter the parameter number to be checked and
press the Load key.
The save setup data will be displayed.
Setup data for parameters that have been set for each axis is displayed for the
respective axis, and the data for parameters that are common for all axes is
displayed for the X-axis.
NOTE
If it is desired to check a different parameter, repeat step 2.
Step 3 Press the Cancel key to quit the parameter setting mode.
No. 99MBE032A
4-13