Step 7 After the hole has been made, press the Load key and call up the target value for
the next hole, then move the machine table and drill the next hole. Each time the
Load key is pressed, the target value is updated, so repeat the same procedure.
Step 8 After machining the holes according to the set number of divisions, the counter
returns to the display of the target value of the first hole.
If machining is complete, or to abort machining, press the Cancel key and quit
the bolt-hole circle machining function.
NOTE
• The input settings are not lost even when the power is turned off. Those setting data is
called up automatically (auto recall) and can be used if desired.
• When the bolt-hole circle machining function ends, the coordinate system used before
the start of the function is returned.
No. 99MBE032A
3-20
