Symbol and name Function
Coordinate switch Switches the coordinate between 0 and 9.
Datum point set key Sets the function for datum point recall
using a scale reference point.
(Possible only when the AT100 series is
connected.)
Touch signal set key Sets the function for datum point setting
with the touch signal.
(Possible only when the AT100 series is
connected.)
Hold key Sets the function to hold the counter display
using the signal from the scale reference
point and touch signal probe.
(Possible only when the AT100 series is
connected.)
1.2.4 Name and function of keys for the lathe counter
The name and function of the function keys and ten-key are given below.
Symbol and name Function
Zero-set key Resets the displayed value of the specified
axis to zero.
Axis-designation
key
• Designates the axis to be set.
• Calls up the previous setting.
• Enables ten-key input.
Cancel key • Cancels the number being entered.
• Cancels the operation being executed.
• Cancels the error.
Load key Loads the entered values.
Number keys Used to enter numbers 0 to 9.
Decimal-point key Sets the decimal point.
Sign key Switches the entered number to negative or
positive.
No. 99MBE032A
1-6
