A SERVICE OF

logo

Open as PDF
next previous
3. BASIC OPERATIONS
3.2.11 Pitch machining
This is the mode in which a certain interval between two points on the X-Y plane can be
machined at even spaces.
For this pitch machining the errors produced from positioning the table can be
automatically corrected.
Setup items and their ranges are shown below:
Setup item Input range
X-axis start point ± 9999.999 mm
Y-axis start point ± 9999.999 mm
X-axis end point ± 9999.999 mm
Y-axis end point ± 9999.999 mm
Number of divisions 999
• Operate with the following procedures.
Step 1 Press the Pitch Machining key.
Step 2 Enter the X coordinate of the start point.
Blinking of the X-axis cursor shows its time to enter the X coordinate of the end
point.
No. 99MBE032A
3-21