CONTROL MODULE PIN OUT INFORMATION
BODY PROCESSOR MODULE
Description
Active
IGNlTlON SWITCHED GROUND
SEAT HEATER STATUS (LHD _ PASSENGER, RHD = DRIVER)
IGNITION SWITCHED GROUND
SEAT HEATER REQUEST ILHD = PASSENGER, RHD = DRIVER)
STARTER ENGAGE REQUEST
SEAT HEATER STATUS ILHD = DRIVER. RHD = PASSENGER)
BATTERY SUPPLY VOLTAGE
SEAT HEATER REQUEST (LHD _ DRIVER, RHD i PASSENGER)
GROUND
GROUND
GROUND
GROUND (MOMENTARY)
GROUND (CRANKING)
GROUND
*+
GROVND (MOMENTARY,
Inactive
B+
B+
B+
B+
B+
B+
St
B+
COMPONENTS
Component Connector / Type I Color
Location
I Access
BODY PROCESSOR MODVLE
SEAT CUSHION HEATERS - DRlVER
SEAT CUSHION HEATERS-PASSENGER
SEAT HEATER SWTCHES
(CENTER CONSOLE SWITCH PAW
FC15, ,4~WAYAMPEEEC,GREY
SM%D, W’JAY MULTILOCK 070, YELLOW
SM7-P, 3-WAY MULTILOCK 070, YELLOW
CC,, 16.WAY FORD IDC S.U.! BLACK
BULKHEAD, BEHIND GLOVE BOX
DRIVER SEAT
PASSENGER SEAT
CENTER CONSOLE SWlTCH PACK
SEAT SQUAB HEATERS - DRIVER
SEAT SQUAB HEATERS- PASSENGER
Smiled, B-WAY MULTILOCK 070, GREY
SMS-Pi 3-WAY MVLTILDCK 070, GREY
DRIVER SEAT
PASSENGER SEAT
RELAYS
Relay
Case Color Connector / Color Location I Access
SEAT HEATER RELAY- DRIVER
SEATHEATERRELAY-PASSENGER
BROWN
BROWN
SMl4-D,BROWN
SMll~P, BROWN
FRONT SEAT RELAYS, UNDER SEAT
FRONT SEAT RELAYS, UNDER SEAT
HARNESS-TO-HARNESS CONNECTORS
Connector Type / Color
Location I Access
CA23 l&WAY MULTlLOCK 070, WHITE
BELOW DRIVER SEAT
CA27 ?&WAY MULTlLOCK 070, WHITE BELOW PASSENGER SEAT
FCI
54.WAY THROUGH PANEL CONNECTOR, BLACK BELOW PASSENGER SIDE AIR VENT, GLOVE BOX ASSEMBLY
FC5 54WAY THROUGH PANEL CONNECTOR, BLACK BELOW DRIVER SIDE AIR VENT, COIN TRAY
FC7 X-WAY MULTILOCK 070 /WHITE ABOVE DIMMER MODULE, COIN TRAY
GROUNDS
Ground Location I Type
CCBL
CA25L
CA26L
EYELET (PAIR) - RH FRONT BULKHEAD STUD, CABIN SIDE
EYELET (PAIR) - PASSENGER SEAT GROUND STUD
EYELET (PAIR, - DRIVER SEAT GROUND STUD
CONTROL MODULE PIN OUT INFORMATION (FOLD OUT PAGE)
4-
The following symbols are used to represent values for Control Module Pin Out data:
I
Input
D
Serial and encoded communications
0 output
B+ Battery voltage
KHz Frequency x 1000
C CAN (Network)
SG Signal Ground
V Voltage (DC)
MS Milliseconds
S SCP Network
Hz Frequency
MV Millivolts
CAUTION: The information on this data page is furnished to aid the user in understanding circuit operation. THIS INFORMATION SHOULD BE USED FOR REFERENCE ONLY.
NOTE: The values listed are approximately those that can be expected at the control module connector pins with all circuit connections made and all
components connected and fitted. “Active” means a load is applied or a switch is ON; “Inactive” means a load is not applied or a switch is OFF.
REFER TO THE FRONT OF THE BOOK FOR ILLUSTRATIONS DETAILING THE LOCATION AND IDENTIFICATION OF COMPONENTS. RELAYS.
CONNECTORS, HARNESSES, GROUNDS, VEHICLE CONTROL MODULES AND CONTROL MODULE PINS.
DATE OF ISSUE: SEPTEMBER 1997
