CONTROL MODULE PIN OUT INFORMATION
BODY PROCESSOR MODULE
Description
Active
IGNITION SWITCHED GROUND
SEAT HEATER STATUS ILHD = PASSENGER, RHD = DRIVER,
IGNITION SWlTCHED GROVND
SEAT HEATER REQUEST iLHD = PASSENGER, RHD = DRIVER)
STARTER ENGAGE REQUEST
SEAT HEATER STATUS iLHD = DRIVER, RHD = PASSENGER)
BATTERY SUPPLY VOLTAGE
SCP NETWORK
SCP NETWORK
SEAT HEATER REQUEST (LHD = DRIVER, RHD = PASSENGER)
GROUND
GROUND
GROUND
GROUND (MOMENTARY,
GROUND iCRANKING
GROUND
B+
2- ,600 Hz
2- 1600 HZ
GROUND (MOMENTARY,
DRIVER SEAT CONTROL MODULE
v Pin
Description
I SMB-ID
I SM3-2D
0
SM3-3D
0 SM3-4D
1 SM3~5D
I SM3-6D
I SM3-SD
S SM3-!3D
S
SMB-lOD
DRIVER SEAT SQUAB FORE, AFT RECLINE MOTOR SUPPLY
DRIVER SEATSQUAB FORE /AFT RECLINE MOTOR SUPPLY
DRIVER SEAT CUSHION RAISE, LOWER FRONT MOTOR SUPPLY
DRIVER SEAT CUSHION RAISE, LOWER FRONT MOTOR SUPPLY
DRIVER HEADREST RAISE, LOWER MOTOR SUPPLY
DRi”ER HEADREST RAISE, LOWER MOTOR SUPPLY
DRIVER SEAT CUSHION FORE, AFT MOTOR SUPPLY
DRIVER SEAT CUSHiON FORE/AFT MOTOR SUPPLY
DRIVER SEAT CUSHION FORE MOVEMENT REQUEST
DRIVER SEAT CUSHION AFT MOVEMENT REQUEST
DRl”ER SEAT CUSHION LOWER REAR MOVEMENT REQUEST
DRIVER SEAT CUSHION RAISE REAR MOVEMENT REQUEST
DRIVER SEAT CUSHION RAISE FRONT MOVEMENT REQUEST
DRIVER SEAT CUSHION LOWER FRONT MOVEMENT REQUEST
DRIVER SEAT SQUAB AFT RECLINE MOVEMENT REQUEST
DRIVER SEAT SQUAB FORE RECLINE MOVEMENT REQUEST
MODULE IDENTlFlCATlON
POWER GROUND
DRIVER SEAT RAISE, LOWER MOTOR SUPPLY
DRIVER SEAT RAISE, LOWER MOTOR SUPPLY
BATTERY POWER SUPPLY
DRIVER SEAT HEADREST RAISE MOVEMENT REQUEST
DRIVER SEAT HEADREST LOWER MOVEMENT REQUEST
SCP NETWORK
SCP NETWORK
Active
B-
B-
B-
B-
B-
B+
Bt
Bc
B+
B+
B+
B+
BT
B-
B-
BT
GROUND
(DRIVER,
GROUND
B+
B+
B-
B,
B+
2- ,600 HZ
2- ,600 Hz
NOTE: REFER TO THE APPENDIX AT THE REAR OF THIS BOOK FOR CAN AND SCP NETWORK MESSAGES.
Inactive
B+
B+
B+
B+
B+
B+
B+
B+
Inactive
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
Bt
GROUND
GROUND
COMPONENTS
Component
Connector I Type I Color
Location / Access
BODY PROCESSOR MODULE
FC15, ,l~WAY AMP EEEC,GREY
BULKHEAD, BEHIND GLOVE BOX
DOOR CONTROL MODULE - DRi”ER
DDIO i 22.WAY FORD 2 8 TIMER, BLUE
DDll , Z-WA,’ FORD 2.8 TIMER, BLACK
DOOR CASlNG /TRIM PANEL
DOOR CONTROL MODULE - DRl”ER REAR
SEAT CONTROL MODULE - DRl”ER
SEAT CUSHION HEATERS- DRIVER
SEAT HEATER SWITCH
iCENTER CONSOLE SWITCH PACK)
SEAT LUMBAR PUMP-DRIVER
SEAT MOTORS-DRIVER
SEAT SQUAB HEATERS-DRIVER
SWITCH PACK - DRIVER SEAT
RDlO, 22.WAY FORD 2.8 TIMER, BLUE
DOOR CASING /TRIM PANEL
RDll I *Z-WAY FORD 2 8 TIMER, BLACK
SMl-D, ,G-WAY FORD 2.8 TIMER, BLACK
DRIVER SEAT, UNDER
SMZ~D ,ZB-WAY FORD IDC, BLACK
SMB-D, ,O-WAY FORD 2.8 TIMER, BLACK
SM7-0, S-WAY MULTlLOCK 070 i YELLOW
DRIVER SEAT
CC?, IS-WAY FORD IDC S “. , BLACK
CENTER CONSOLE SWITCH PACK
SMlO-D, 3-WAY MULTlLOCK 070, YELLOW
DRIVER SEAT
SMI-D, S-WAY MULTILOCK 070, GREY
DRIVER SEAT, UNDER
SMS-D, S-WAY MULTILOCK 070, YELLOW
SM, I-D, 6.WAY MULTILOCK 070, WHITE
SM12-D/B-WAY MULTILOCK 070, WHITE
SM13-0, S-WAY MULTlLOCK 070, YELLOW
SMS-D ,3-WAY MULTILOCK 070, GREY
DRIVER SEAT
SMS-D, 16-WAY MULTILOCK 040, BLACK
DRIVER SEAT
RELAYS
Relay
Case Color
Connector / Color
Location / Access
SEAT HEATER RELAY- DRIVER
BROWN
9414-D, BROWN
FRONT SEAT RELAYS, UNDER SEAT
HARNESS-TO-HARNESS CONNECTORS
Connector
Type / Color
Location / Access
CA8
CJ413
CA23
FC1
FC5
FC7
?&WAY MULTILOCK 070, WHITE
S-WAY M”LTlLQCK 070, WHlTE
IO-WAY MULTILOCK 070, WHITE
5CWAYTHROUGH PANELCONNECTORiBLACK
54.WAY THROUGH PANEL CONNECTOR, BLACK
Z&WAY MULTILOCK 070 /WHITE
DR,“ER ‘Y!’ POST, DOOR HARNESS GAITER
DR,“ER ‘B,C POST, DOOR HARNESS GAlTER
BELOW DRIVER SEAT
BELOW PASSENGER SIDE AIR VENT, GLOVE BOX ASSEMBLY
BELOW DRIVER SIDE AIR VENT, COIN TRAY
ABOVE DlMMER MODULE, COIN TRAY
GROUNDS
Ground Location I Type
CA25L
CAER
CA26L
CA26R
CCSL
EYELET (PAIR, - PASSENGER SEAT GROUND STUD
EYELET (PAIR) PASSENGER SEAT GROUND STUD
EYELET ,PAlR, - DRIVER SEAT GROUND STUD
EYELET iPAIR - DRIVER SEAT GROUND STUD
EYELET (PAIR) - RH FRONT BULKHEAD STUD, CABIN SIDE
CONTROL MODULE PIN OUT INFORMATION (FOLD OUT PAGE)
The following symbols are used to represent values for Control Module Pin Out data:
I
Input
D Serial and encoded communications
B+ Battery voltage
KHz Frequency x 1000
0 output
C CAN (Network)
V Voltage (DC)
MS Milliseconds
SG Signal Ground
S SCP Network
Hz Frequency
MV Millivolts
CAUTION: The information on this data page is furnished to aid the user in understanding circuit operation. THIS INFORMATION SHOULD BE USED FOR REFERENCE ONLY.
NOTE: The values listed are approximately those that can be expected at the control module connector pins with all circuit connections made and all
components connected and fitted. “Active” means a load is applied or a switch is ON; “Inactive” means a load is not applied or a switch is OFF.
REFER TO THE FRONT OF THE BOOK FOR ILLUSTRATIONS DETAILING THE LOCATION AND IDENTIFICATION OF COMPONENTS, RELAYS,
CONNECTORS, HARNESSES, GROUNDS, VEHICLE CONTROL MODULES AND CONTROL MODULE PINS.
DATE OF ISSUE: SEPTEMBER 1997
