Filter
Top Products
ilO.
: Make electrical connection. See
/ ‘Electrical requirements,’ Page 3.
Move dryers to their
permanent location.
‘1 1
.
Check levelness of dryers by
placing a carpenter’s level on top
of the dryers or collar, first side to
side, then front to back. If dryer is
not level, adjust the front legs up or
down. Make the final check with
the level.
1
I
To exhaust the dn/ers, see ‘Exhaust
requlremenk’ and ‘Exhaust duct
( connection’, Pages 6.7 and 8.
Personal Injury Hazard
~ To prevent tlpping. tether
bracket must be secured to wall
studs or concrete wall.
Failure to do so could result in
personal Injury.
: Tether bracket, : Tether bracket,
located at rear located at rear
of the top dryer. of the top dryer.
I I
1 1
1 Attach both ends 6f tether
! located at the rear of the top
/ dryer to a secured 2x4.
1 Attach both ends 6f tether
! located at the rear of the top
/ dryer to a secured 2x4.
14
.
) Check to see that all parts you
removed from the Installation
parts packages are now installed
I in the dryers. If you have an extra
part, go back though the steps to
see what you skipped.
15
n
Check to make sure you have ? all
your tools.
Numbers
correspond
with steps.
ib I
Turn on electrIcal power supply.
The installation of
your electric dryers is
now complete.
Page 11