Filter
Top Products
TABLE1 SIA StateFile Variables (Continued)
Variable Description(DefaultsinBold)
Requiredfor
LinuxInstall
Required
for
Firmware
Upgrade
apit.osid.kickstart Tells SIA wherethe kickstart le is located fora Linux
installation. This couldbe the URL to the RedHat
kickstart le orthe SUSE autoyast le.
Examples:
apit.osid.kickstart=http://url_to_kickstart
apit.osid.kickstart=ftp://url_to_kickstart
apit.osid.kickstart=nfs://url_to_kickstart
X
apit.enclosureID.oldEnclosureID Used as partof a two-step process that allowsyou to
replace a SunBlade 6000 disk module. The valuefor
this variable mustbe the old enclosure ID number
(also called WWN)that can be found on thecircuit
board of theblade being replaced.
apit.enclosureID.newEnclosureID Used as partof a two-step process that allowsyou to
replace a SunBlade 6000 disk module. This valuefor
this variable mustbe the new enclosure ID number
(also called WWN)that can be found on thecircuit
board of thereplacement blade.
apit.rmware.enabled Tells SIA toenable or disable its rmware update
function. Values supported:true | false
Typically used ina test environment, this variable is
not required toupgrade rmware.
apit.rmware.spIP Partof a rmware upgrade task. TellsSIA theIP
address of theserver’s service processor.
Example: apit.rmware.spIP=n.n.n.n
X
apit.rmware.spPasswd Partof a rmware upgrade task. TellsSIA the
password of theserver’s service processor.
Example: apit.rmware.spIP=changeme
X
apit.done.notifyUrl Tells SIAto access the specied URL followingthe
completion of enabledSIA tasks. Thisis currently
only supported forSun N1 System Manager.
Example:
apit.done.notifyUrl=http://my_destination_url
Contentsofthe SIAStateFile
47