Filter
Top Products
Grounding the machine
The machine must only be operated
with the voltage, frequency and fusing
shown on the data plate located on the
rear of the machine, and on the plinth
(behind the service panel).
The conversion diagram and the
wiring diagram is secured to the inner
side of the service panel.
Remove the service panel and plinth
,
Disconnect the machine from the
main electrical supply.
^
Remove the fixing screws, a, from
the service panel.
^
Take hold of the service panel at both
sides and pull upwards.
^
Unscrew plinth facing (screws b).
^
Remove plastic protective cap.
Re-assembling the service panel
^
Replace the plastic protective cap,
plinth facing and service panel in the
reverse order.
^ See the supplied installation diagram.
Electrical connection
48