Filter
Top Products
Please refer to the installation
diagram supplied with the machine.
,
Furniture and fittings installed
near the machine must be of a
commercial standard, able to
withstand the effects of steam.
Installation options
–
Free-standing
–
Slot-in, next to other machines or
furniture or in a suitable space. The
space must be at least 35
7
/
16
" (90
cm) wide and 29
7
/
16
" (70 cm) deep.
– Undercounter
The machine can be installed under a
continuous counter or sink drain.
The niche must be at least:
Width 35
7
/
16
" (90 cm)
Depth 29
7
/
16
" (75 cm)
Height 32
5
/
16
" (82 cm).
The labwasher can be built into a
recess of 32
5
/
16
" (82 cm) high by
removing the lab washer top.
Leveling the legs
Any unevenness in the floor can be
compensated for and the height of the
machine raised or lowered by adjusting
the four screw feet.
When the feet are screwed in, the
machine can be moved back and forth
on its rollers.
Removing the lid (if necessary)
^
Open the door.
^
Remove the fixing screws on both
sides using a cross slotted
screwdriver.
^ Pull the machine lid approx. 5mm
forwards, lift upwards and remove.
Protecting the countertop
(depending on model)
Important for machines with steam
condenser (depending on model):
To prevent steam damage to the
countertop, adhere the protective foil
9
13
/
16
" x 22
13
/
16
" (25 x 58 cm)
underneath the countertop near the
steam condenser.
Depending on the requirements for
installation, the following kit can be
ordered from the Miele Technical
Service Department.
Cover plate (protects the countertop)
The underside of the countertop is
protected from steam damage by a
stainless steel plate.
Installation
43