Filter
Top Products
In operating level C the optional
Automatic mobile unit recognition
(AWK) feature attributes a fixed
program place to a mobile unit with
valid coding.
Program places 1-15 are reserved for
the AWK automatic mobile unit
recognition.
The unit coding (on the mobile unit)
and the program place with the
corresponding program (in the
"Profitronic" electronic control unit)
must be matched up.
^ Each mobile unit must be coded
before being used for the first time.
See "Coding the mobile unit".
^ The wash program through which the
mobile unit is coded has to be
assigned to the relevant program
place (operating level D, see the
"System function - Selector
Organization" section in the
Programming Manual).
Important!
Before starting the program with the
"Start" button 6, check if the
program needed for this mobile unit
is displayed.
Insufficient wash results may occur!
Always check that programs for
mobile units with AWK (on fixed
program places) are not exchanged.
Mobile unit coding
The AWK assigns a program place to a
mobile unit. The mobile units must be
coded with a magnetic strip via a Bit
combination. In operating level C the
only program available for a coded
mobile unit is the one assigned to the
corresponding program place.
After a coded mobile unit has been put
in the machine and the door is closed,
the control unit selects the allocated
program. Press 6 to start the program.
Coding is affected through 5 Bits:
– Bit 1 through 4 define the mobile unit
code,
– Bit 5 serves as a control (Parity-Bit).
Automatic mobile unit recognition (AWK)
16