Filter
Top Products
51
It does not work after setting of
air-jet dry
設定風乾後無法工作
• if there is water remained in the dehydrating basket, Start button
can not be pressed. And it can only be pressed after draining all
of the water.
脫水槽中有水積存時，就不能按“ ”鍵，要先進行排水，把水排
光後再按“ ”。
Water can not be reserved
不能儲水
(when pouring the water with water basket)
（用水桶等灌水）
• Is the power switched on?
電源開關接通了沒有？
If the power supply is switched off or failed during drainage, the
drainage valve will be in open position. After power on,valve closes.
排水中途切斷電源或停電時，排水閥處於打開狀態。接通電源，閥關閉。
Failure to supply water 不供水
No spinning, washing basket
cannot rotate
不脫水、洗衣槽無法旋轉
No stirring 不攪拌
Please refer to "Part to check" in "About abnormality
alarm". 49
請參照關於異常警報中的「檢查部位」。
49
Unable to air-jet dry
無法風乾
•
Please refer to "The Approximate air-jet duration of laundry". 39
請參照衣物的大致風乾時間。 39
Can not open the lid
機蓋打不開
• If there is outage and shutdown during the operation, the wash-
ing machine will generate alarms and cut off the power supply.
The lid is still locked. When power supply is switched on again,
the lid lock will be unlocked.
電源開關是否打開？
（運轉過程中出現斷電或停電時，洗衣機將發出異常警報並自動切斷
電源，機蓋仍處於鎖定狀態。再次接通電源後，機蓋緊鎖將解除。）
Abnormal sound occurs
發出異常聲音
•
Is the washing machine declining or shaky? 8 Installation Guide
洗衣機是否有傾斜或搖晃？ 8 安裝指南
• Is any barrette or metal item mixed in the washing basket?
有無髮夾或金屬物體混入洗衣槽內？
No buzz at the end of washing
洗衣結束後無蜂鳴聲
• Is the buzz at the end of washing set as cancelled? 16
是否已設定取消洗衣結束蜂鳴聲？ 16
The lid cannot be opened during
the operation.
運轉過程中，機蓋無法打開
• The washing machine has been set the safety protection
mode during the operation. If opening the lid, please press the
"START/PAUSE" button. 16
本機在運轉過程中就已經設定了安全保護模式，如要打開機蓋請按
“ /暫停”鍵。 16
Water leakage
漏 水
The indication for Auto Self Clean disappears
自動筒清洗的顯示消失
Cannot set Auto Self Clean
無法設定自動筒清洗
Auto Self Clean function setting, but no action
即便設定了自動筒清洗也不動作
• Is the tap of proper shape? 10
水龍頭的形狀是否合適？
10
•
Are the one touch joint and the connection nut unfastened? 10
便捷連接器和連接螺母是否出現鬆動？ 10
• If the choice of Auto Self Clean program cannot be set automati-
cally.
是否選擇了不能設定自動筒清洗的程序。
• If the washing is one side imbalance?
洗衣物是否偏向一邊不平衡？
• Can Auto Self Clean be set for the selected program?
是否選擇了不能設定自動筒清洗的程序？
• Is the function set to "no spin"?
是否設定為不脫水？
•
If it has been set to "spin for 1 minute", "spin only" or "no spin" manu-
ally, the [Auto Self Clean] function will be released automatically.
手動設定為脫水1分鐘或僅脫水、不脫水的話，「自動筒清洗」功能會自動解除。
Case 現 象 Cause 原 因
• Except the failures mentioned above, the lid lock protector may cause cases such as stopping during operation or lid being unable to be
opened. In such a case, please unplug the power supply unit. Plug it back after 5 minutes, and then reset operation.
除了上述故障外，如發生運行中途停止或機蓋無法打開的現象，是機蓋緊鎖開關保護器動作。此時，請拔下電源插頭，五分鐘後再插上，重新設定並運行即可。