Hitachi BW-80S Washer User Manual


 
16
1
Press the "POWER" button to power on.
ྈʁヅ᜺⿭〦ྈ⸹Ŋ࿲ⳇヅ᜺ȯ
2
Press and hold "RINSE" button for over three seconds.
Ⳑ↲ྈȵᗢᘺȶྈ⸹ 3ấ⾝˫ʀȯ
To return to rhythm sound, press and hold "RINSE" button for over three seconds again.
บⲙⲪᅩയ⊖ᆹҪɺᓝⳐ↲ྈȵᗢᘺȶྈ⸹3 ấ⾝˫ʀȯ
Various rhythms emit after setting. It will inform of the following signal after setting completes: "prolonged P" when muted (with
button clicking sound), "short and discontinuous P" when button clicking sound is muted.
⥑હര㏦פ׳Ớᅩയȯ⥑હ⃌ታሳⳇᵧŊΒ⚦ᣅŘ㄃ㅠņሷྈྈ⸹⊖Ňᆹơ⿢ㅠPƢŊྈྈ⸹⊖ᣅ㄃ㅠᆹơᵬ≟⿵ᅜ PƢȯ
ȘThe completion sound (within 10 minutes) can be cancelled by pressing and holding START button
for 3 seconds after power on. To return original rhythm, please execute with the same procedure. The sound
after setting should be "P, P, P-". The sound after canceling setting should be "P, P, P".
⃌ታㅷب⊖ņ߱10Ӡ⾝ҙŇ߱ヅ᜺⿭〦࿲ⳇരⳐ↲ྈ ྈ⸹3ấ⾝˫ʀר˫ᚉぜȯⲙߊ׆ሷᅩയᆹŊ⦼ྈ᳈
׺ᅞᘍႽ̳ȯ⥑હര㏦פ⊖ㅠᣅ
"P ŊP ŊP ŋ"ȯ⤟ぜര㏦פ⊖ㅠᣅ "P ŊP ŊP" ȯ
(During spinning, the buzzer will not sound if caused by safe switch operation and spinning correction due to the uneven laundry
arrangement.)
ņ⌉ᖛʑŊߌ⠥᧎ʃ౹⠣೧⬚મҚ⿭〦Ւ̳ᆹ⌉ᖛ₉ᔌര✙㏦ݽʃפȯŇ
When want to change buzzer sound
శቃᄊ⩐✙㏦⊖ᆹ
The sound alert can be turned into common electronic buzzer sound.
⊖ㅠ⨸ࢊר˫Ⱨ⩐ᣅᇒⳇヅઈ✙㏦⊖ȯ
In addition, the buzzer sound can be cancelled at end of cancellation. Please execute the following process.
ʬר˫חᚉ⃌ታᆹ᱿✙㏦⊖ȯ⦼ྈ˫ʁỄ಍Ⳗ⠗ȯ
When want to turn rhythm sound into buzzer sound
บ૽ᅩയ⊖Ⱨ⩐ໞ✙㏦⊖ᆹ
Mixing sound 1
(initial setting)
ᛜ㆒1
(Ӯቅ⥑હ)
Mixing
sound 2
ᛜ㆒2
Mixing
sound 3
ᛜ㆒3
Mute (with
button
clicking
sound)
㄃ㅠ(ሷྈྈ
⸹⊖)
Mono
sound
track
܈⊖ⳬ
Mute
㄃ㅠ
The lid will be locked automatically after water supply for children's safety.
為防止意外傷害及保護兒童的安全,洗衣過程中供水開始後,洗衣機會自動將機蓋鎖緊。
With the set of safe mode, the lid will be
locked as the washing machine restarts.
Without the set of safe mode, the lid will be
locked automatically during spinning.
在設定為安全保護模式時,洗衣機再 時機蓋會立即
被鎖緊。
若沒有設定安全保護模式,在脫水時機蓋會自動鎖緊。
Press "START/PAUSE" button Lock will
be removed automatically when tub stops rotating.
Lid can be opened.
按下「 /暫停」按鈕
旋轉結束,鎖緊解
除,可打開機蓋。
1
Press POWER ON/OFFbutton .
按下「電源開/關」按鈕
3
Cut off the power supply.
切斷電源。
2
Press and hold the "WASH" button for at least three seconds, then the safe mode can be removed.
持續按住「洗衣」按鈕 3秒鐘以上,可解除安全保護模式。
• Press and hold the "WASH" button for at least three seconds again to set the safe mode.
再持續按住「洗衣」按鈕 3秒種以上,可設定安全保護模式。
About the Lid Lock Hold
關於機蓋緊鎖裝置
Lid Lock function 機蓋緊鎖功能
Remove safe mode 解除安全保護模式
When you want to open the lid 想打開機蓋時
When beginning again
When setting
設定時
Indicator
lighted
點燈亮
When unlocking
解除時
Indicator
turns off
點燈滅