Filter
Top Products
34 EN
Cycle time takes longer
than the time specified in
the owner’s guide.
Water pressure may be low.
The washer will wait until there is a
sufficient amount of water, which
may lengthen the cycle time to
avoid poor washing results due to
insufficient water.
Supply voltage may be low.
Cycle time is lengthened to avoid
poor washing results when the
supply voltage is low.
Inlet temperature of water may
be low.
Cycle time lengthens to heat up
the water when the inlet water is
cold. Also, washing time can be
lengthened to avoid poor washing
results.
There may be an imbalance of
load in the drum.
The automatic spin correction
system might have been activated
due to the unbalanced distribution of
the laundry in the drum.
Number of rinse cycles might
have increased to obtain a better
rinse.
Use a proper amount of HE
detergent. Reduce the amount of
detergent next time you operate the
washer.
It continuously washes.
Remaining time does not
count down.
In the case of a paused
countdown while taking in water:
Timer will not countdown until
the washer is filled with the
correct amount of water. Time
will not count down until the
selected temperature for the
program is reached
The washer will wait until there is a
sufficient amount of water to avoid
poor washing results due to lack
of water. Then the timer will start to
count down.
In the case of a paused
countdown at the heating step:
Time will not count down until
the selected temperature for the
program cycle is reached.
In the case of a paused
countdown at the spinning step:
There may be an imbalance of
laundry in the drum.
The automatic spin correction
system might have been activated
due to the unbalanced distribution of
the laundry in the drum.
The laundry in the drum may be
tangled up too much. Laundry
should be rearranged and re-spun.
No spinning is performed when the
laundry is not evenly distributed in
the drum to prevent any damage to
the appliance and to its environment.