Filter
Top Products
23 EN
• : Selectable
* : Automatically selected, not
cancellable.
- : See program description for
maximum load.
Selectable options of a wash cycle are
extra rinse “R”, super wash “SW”, soak
"S", rinse hold "RH" and anti crease “A”.
1. Even if there is no hot water
system, hot water inlet must still be
connected to another cold water
faucet. Otherwise a fault will occur on
water intake.
2.Programsarelimitedwiththe
maximum spin speed appropriate for
that particular type of load.
3. Maximum load capacities are
suggested for various load types.
Wash cycles of full load (Regular/
Cotton, permanent press) should be
half loaded for better wash results
if the laundry is heavily soiled. Half
loading would also minimize wrinkling
of the load.
4. Bleach may only be used in Regular/
CottonandPermanentPresscycles.
Don’t use bleach with delicates,
handwashables, wools, jeans and
sports, this will lead to clothes
damage.
C The auxiliary functions in the table
vary according to the model of your
washer.
C Water and power consumption and
program duration differ from the
table subject to changes in water
pressure, water hardness and
temperature, ambient temperature,
type and amount of laundry, selection
of auxiliary functions, and changes in
supply voltage.
CProgramdurationwillbedisplayedon
the screen of your washer according
to your selection.
Auxiliary functions
Auxiliary Function Selection Buttons
a b c d
•Dependingontheprogram,youcan
select the desired auxiliary function by
pressing the buttons a, b, c, d.
•Selecttherequiredauxiliaryfunctions
before starting the program.
•Symboloftheselectedauxiliary
function will light up.
Auxiliary function selection
Auxiliary function that is not compatible
with the program cannot be selected.
(see, “Program Cycle Selection Table”)
• Super Wash
This function increases washing times
for heavily soiled items for better wash
results. Washer will only take in cold
water when this function is chosen. This
function also increases the amount of
rinse water for “Regular/Cotton” cycle.
• Soak
This function ( b) is used for heavily
soiled items when you want to pre-
treat them before washing. Laundry
is soaked in a relatively high amount
of warm water for an hour and a half
approximately. You can use full load
and HE “High efficiency” detergent
for soaking. Use 1/3-1/2 of the
recommended detergent dosage for the
load amount to be soaked.
• Extra Rinse
When this function ( c) is selected, you
can increase the number of current
rinsing steps. Thus, sensitive skins’
risk of being affected by the remaining
detergent on the clothes will be