Filter
Top Products
21 EN
rinse cycle. It is recommended for baby
clothes and clothes worn by allergic
people.
• Hand wash
You can wash your woolen/delicate
clothes that bear “hand wash only”
labels for which hand wash is
recommended on this program. It
washes the laundry with very tender
washing movements without damaging
your clothes.
• Quick Wash
This program is used to wash a few
very lightly soiled and unstained cotton,
synthetics or blended items in a short
time. e.g.: daily clothes that have been
used only once.
• Sports
This program is used to wash half
capacity of normally or lightly soiled daily
cotton, synthetics or blended clothes.
e.g.: daily clothes and sportswear that
have been used only once.
• Jeans
This programme is used to wash half
capacity of normally or lightly soiled
jeans and denim jackets. Turn your jeans
or jackets inside out before washing.
You shouldn’t wash more than four pair
at a time, this may cause an unbalanced
load in the washer.
Special programs
For specific applications, select any of
the following programs:
• Rinse
This cycle is used when you want to
rinse separately.
• Drain & Spin
This program is used to discharge
the water and spin dry the load with
selected spin speed. Spin&Drain may be
selected as one program in this model.
C
You should select a lower spin speed
for delicate wash items.
Temperature selection
Whenever a new program is selected,
the temperature anticipated for that
program appears on the temperature
indicator.
To change the temperature, press
the temperature button (Figure 2-9).
There are four temperature options
being cold,warm,hot and extra hot.
Temperature selectability depends on
the type of wash cycle.
When the “Temperature” button is
pressed after Cold is selected, the
maximum temperature of the program
you have selected will be displayed.
To decrease the temperature, press the
“Temperature” button again.
Spin Speed selection
Whenever a new program is selected,
the maximum spin speed of the selected
program is displayed on the spin speed
indicator.
To decrease the spin speed, press
the “Spin” button (Figure 2-7). Spin
speed decreases gradually. Then, rinse
hold and no spin options are shown
respectively.
You can use no spin function in order to
drain the water without spinning at the
end of the program.