Blomberg WM 87120 NBL00 Washer User Manual


 
29 EN
A WARNING – Be sure to unplug
the power cable before attempting
maintenance or cleaning of your
appliance to minimize the risk of
electric shock.
Cleaning detergent dispenser
Remove any powder/liquid residue
buildup in the dispenser drawer. To do
this;
1.Pressthedottedpointonthesiphon
of the softener compartment and
pull towards yourself until the it is
removed from the dispenser.
3 If more than a normal amount of
water and softener/bleach mixture
starts to gather in the dispenser
compartments, dispenser must be
cleaned.
2. Wash the dispenser drawer, liquid
chlorine bleach container and siphon
of softener under running warm
water in a sink etc. Wear protective
gloves or use an appropriate brush
or sponge to avoid touching the
detergent residues in the drawer
when cleaning.
3. Replace the drawer into its housing
after cleaning. Check if the siphon
and container are in their original
locations.
Cleaning the door seal
Be sure to check the rubber door seal
afterunloadingyourwasher.Pulltheseal
back to search for any foreign objects.
Residual metal objects such as pins and
coins may form rust stains on rubber
seal, and cause the seal to leak.
Wipe the stained areas with soapy
water using a damp cloth. Then wipe
with a dry cloth properly. Do not use an
abrasive scrubbing agent when cleaning
rubber seal.
Cleaning the drum
Check the wash drum for any foreign
objects after unloading your washer.
Residual metal objects such as pins
and coins may form rust stains on drum
surface and your clothes. Do not use
abrasive materials while cleaning the
inner surface of the drum. Use soapy
water with a damp cloth to wipe the
inner surface, then dry it and leave the
door open to let inside dry properly.
Sanitary cycle with extra rinse option
should be used for monthly cleaning of
drum. To carry out this procedure:
First be sure that the drum is empty.
Add 80ml of liquid chlorine bleach
to the bleach container in the right
compartment of the dispenser.
Select sanitary cycle, close the door
and press “start/pause” button. At the
completion of cycle, leave the door open
for drying of drum interior.
Monthly cleaning of the washer is
necessary for removal of bacteria
and mold residues and prevention of
unwanted odor in wash drum.
Cleaning the outer cabinet
and control panel
When necessary:
• Wipetheexteriorpanelsofyour
washer with soapy water or mild
detergent. Dry it with a soft cloth.
• Useonlyasoftanddampclothto
clean the control panel.
C Never use a sponge or scrubbing
material. These will damage the
7 User maintenance instructions