Filter
Top Products
32
I. PREPARATION FOR OPERATION
The following items should be checked before attempting to operate the dryer:
1. Read ALL "CAUTION," "WARNING," and "DIRECTION" labels attached to the dryer.
2. Check incoming supply voltage to be sure that it is the same as indicated on the dryer data label affixed to the
back side of the top front control/service door.
3. Check to assure that the dryer is connected to the type of heat/gas indicated on the dryer data label (for GAS
MODELS ONLY).
4. The sail switch damper assembly is installed and pre-adjusted at the factory to dryer shipment. However,
the sail switch adjustment must be checked to assure that this important safety control is functioning (for
GAS MODELS ONLY).
5. Check bolts, nuts, screws, terminals, and fittings for tightness.
6. Be sure ALL gas shut-off valves are in the open position (for GAS MODELS ONLY).
7. Check ALL back guard panels and service box covers have been replaced.
8. Make sure the lint coop support bracket has been removed.
9. Check the lint door to assure that it is closed and secured in place.
IMPORTANT: If during installation the lint door safety chain was disconnected, it must be
reconnected or personal injury may result.
10. Rotate the basket (tumbler) by hand to be sure it moves freely.
11. Check to insure ALL steam shut-off valves are open (for STEAM MODELS ONLY).
12. Check to insure that a clean, dry, regulated air supply (80 psi) is on the dryer (for STEAM MODELS with air
operated DAMPER SYSTEMS ONLY).