Filter
Top Products
35
2. Follow Step #4 and Step #5 under To Replace Impellor.
3. Loosen the four (4) bolts securing the fan shaft assembly to the base of the dryer.
NOTE: Models with rear access, it may be easier to remove this plate, to remove the two (2) rear
fan shaft assembly bolts.
4. Remove the fan assembly through front access hole.
5. Loosen the set screws in each bearing.
6. Loosen the four (4) flange bolts and two (2) pillow block bolts.
7. Using a pulley, remove the bearing needing replacing.
8. Reverse the procedures to reinstall new bearing.
L. IMPELLOR
1. Discontinue electrical power to the dryer.
2. Remove the left side lint wall if necessary for easier access.
3. Remove the six (6) nuts securing the inlet cone to the blower housing.
4. Remove the two (2) left handed jam nuts that hold the impellor to the fan shaft.
5. Remove the impellor, washers, and the key.
6. Replace the impellor, key, washers, left handed jam nuts, and the side panel.
7. Reestablish electrical power to the dryer.
M. LINT DRAWER ASSEMBLY
To Replace Lint Screen
1. Pull out lint drawer.
2. Remove lint screen from lint drawer.
3. Drop new lint screen in place.
4. Slide lint drawer back into dryer.