Filter
Top Products
32
5. Replace by reversing procedure.
6. Reestablish electrical power to the dryer.
I. BASKET and SUPPORT
To Replace Tumbler (Basket) and Tumbler (Basket) Support
1. Discontinue electrical power to the dryer.
2. Follow procedure for removal of main door assembly.
3. Follow procedure for removal of front panel assembly.
4. Remove bearing back guard.
5. Remove tumbler (basket) assembly and support.
a. Loosen the two (2) set screws on the flange bearing.
b. Remove the retaining ring from the groove of the tumbler (basket) shaft.
c. Remove the rotational sensor magnet from the tumbler (basket) support shaft.
d. Remove the tumbler (basket) and support assembly from the front of the dryer. If the tumbler (basket)
cannot be removed freely, clean the shaft area and spray WD-40 or similar lubricant. With a block of
wood against the shaft end, strike the block wood with a hammer or mallet to move the shaft past any
burrs made by the set screws.
IMPORTANT: Never strike the shaft directly with a hammer.
6. Reverse these steps for installation of new tumbler (basket) and tumbler (basket) support.
7. Reestablish electrical power to the dryer.
J. V-BELTS (See illustrations in section F Pulleys)
V-belts should have proper tension. If too loose, they will slip, excessive wear on the bearings will result. If the
pulleys are not properly aligned, excessive belt wear will result. Proper belt tension will allow 1/2 displacement
under normal thumb pressure at mid span of belt.
NOTE: Belts must always be replaced in pairs (matched sets).