Filter
Top Products
6
90 DAYS
Remove lint from tumbler (basket), drive motors, and surrounding areas. Remove lint from gas valve burner area
with a dusting brush or vacuum cleaner attachment.
NOTE: To prevent damage, avoid cleaning and/or touching ignitor/flame-probe assembly.
Remove lint accumulation from inside control box and at rear area behind control box.
6 MONTHS
Inspect and remove lint accumulation in customer furnished exhaust duct work system and from dryers internal
exhaust ducting.
WARNING: THE ACCUMULATION OF LINT IN THE EXHAUST DUCT WORK CAN
CREATE A POTENTIAL FIRE HAZARD.
WARNING: DO NOT OBSTRUCT THE FLOW OF COMBUSTION and VENTILATION
AIR. CHECK CUSTOMER FURNISHED BACK DRAFT DAMPER IN
EXHAUST DUCT WORK. INSPECT and REMOVE ANY LINT
ACCUMULATION WHICH CAN CAUSE DAMPER TO BIND or STICK.
NOTE: A back draft damper that is sticking partially closed can result in slow drying and shut down
of the heat circuit safety switches or thermostats.
NOTE: When cleaning dryer cabinet(s), avoid using harsh abrasives. A product intended for the
cleaning of appliances is recommended.
B. ADJUSTMENTS
7 DAYS AFTER INSTALLATION and EVERY 6 MONTHS
Inspect bolts, nuts, screws, (bearing set screws), nonpermanent gas connections (unions, shut-off valves, orifices,
and grounding connections). Motor and drive belts should be examined. Cracked or seriously frayed belts
should be replaced. Tighten loose V-belts when necessary. Complete operational check of controls and valves.
Complete operational check of ALL safety devices (door switch, lint drawer switch, sail switch, burner and hi-
limit thermostats).
C. LUBRICATION
The motor bearings, idler bearings...and under normal/most conditions the tumbler bearings are permanently
lubricated. It is physically possible to re-lubricate the tumbler bearings if you choose to do so even though this
practice is not necessary. Use Shell Alvania #3 or its equivalent. The tumbler bearings used in the dryer DO
NOT HAVE a great fitting. Provisions are made in the bearing housing for the addition of a grease fitting which
can be obtained elsewhere, or from ADC by ordering kit Part No. 882159, which includes two (2) fittings.