Filter
Top Products
34
K. MOTORS
To Replace Drive Motor
1. Discontinue electrical power to the dryer.
2. Remove the lint drawer.
3. Remove the lint door.
4. Remove the left lint wall.
5. Remove the drive V-belts. Follow V-belt replacement
from motor to speed reducing shaft.
6. Loosen the four (4) bolts securing the motor to the base of the dryer.
7. Disconnect the motor wiring.
8. Remove old motor pulley and bushing and place on new motor.
9. Reverse these steps to replace drive motor.
To Replace Impellor Motor (Fan Shaft Drive - 50/60 Hz Gas and Steam Models)
1. Discontinue electrical power to the dryer.
2. Remove the lint drawer.
3. Remove the lint door.
4. Remove the left hand lint wall.
5. Loosen the four (4) mounting bolts securing the motor.
6. Loosen the tension bolts.
7. Remove V-belts.
8. Disconnect motor wiring.
9. Remove the motor pulley and bushing.
10. Reverse these steps for installation of new motor.
To Replace Fan Shaft and/or Fan Shaft Bearings
A. To remove from the front
1. Follow Step #1 through Step #8 under To Replace Impellor Motor.